2*3M Automatic pressure autoclave PLC system and cylindric and
single drum structure
φ1500-4700L(according to customers' requirements). The interlock
device is the first important point to ensure acceptance of the
product. The equipment can be heated by electric,steam or
conductive oil. Before working, pressure,time, as well as
temperature could be adjusted on control panel.
Automatic pressure 0.7~0.8Mpa
Entire pressure 0.4Mpa
Entire working time When the time is up to 100 degrees, pressure is 0.48Mpa, the
machine begin automatic work.
Operating after manual closing the door, the fast opening door motor
contact, push the close button, the Vulcanizing boiler enter the
status of self-control
indirect heat: electric or indirect steam
direct heat: direct steam
Basic temperature/pressure controls
prepackaged in C/S Nema 12 enclosure
24 hour circular chart recorder
Programmable Logic controller
max. flexibility to program autoclave process cycle
Optimization of autoclave cycle for desired results
effective tool for achieving high quality products
modern hookup capabilities;
Specifications and Parameters
1. Glass industry
2. Brick industry
3. Rubber industry
4. Food industry
5. Wood industry
6. Composite materials
7. Textile industry
8. Aerospace industry
Safety interlock types:1)pressure automatic safety interlock; 2)
manual safety interlock. These two types get rid of misoperation
Controlling methods:adopt electrical automatic control,PLC computer
automatic control,manual control. We will customize suitable method
for your line according to your requirements.
Pressure of horizontal vulcanizing tank is generally below 1.2Mpa
and it belongs to low pressure vessel.Its structure is cylindric
and is of single drum.The tank consist of
body,cover,switch,clock,heating device and other devices.
Vulcanizing tank now is widely applied to
rubber,cables,dyeing,chemistry,building materials and other
industries. Key points of the whole process is temperature,pressure
and time. In case of mis-operation, there will be risk of
explosion. In order to get rid of this, we recommend you the
following methods and advice.
Operation of the equipment
First of all,operators shall be professionally trained and be told
that they shall operate strictly with rules and instructions to get
rid of risks arisen from operators being unfamiliar with production
process. Secondly,check equipment thoroughly and remove all
obstacles around it before running it. And check the tightening
screw of the cover again, as well as all gauges,signal
transmission,safety devices and so on.
During production process,if there is situation of abnormal leakage
or abnormal gauge display,operator shall stop and check and find
out reasons. In daily work,operators shall regularly check safety
valves,pressure gauges to keep their correct running .During the
production process,operator shall tour around side of the tank and
should not leave.
This tank has automatic controlling function.It could control
vulcanizing temperature,pressure and time through PID to realize
high-quality products,temperature compensation,automatic
alarm,automatic timing.And PLC automatic controlling system could
be additionally added to set temperature,pressure and other
parameters. All these data could be saved and printed out.PLC
system could also be connected to the computer to do remote
diagnose and update. Adopt flange and compressed air safety
interlock device. Its heating system could be electric
heating,steam heating and thermic oil heating.The tank adopts
temperature relay to control temperature within a range of
1-2℃.Body plate thickness is 10mm and could stand 10KG pressure.
rew of the cover again, as well as all gauges,signal
transmission,safety devices and so on.
OLYMSPAN---Manufacture& trading company
We are a manufacture and trading company located in Changzhou.
Welcome to pay a visit to our company and have face-to-face
discussion with us!
Installation and after-sale service:
We provide omplete installation and operation manual in English for
All our machine have one year warranty from the date of products
leaving our factory against any manufacturing defects of the